Filter
Top Products
ENWW HP Jetdirect Configuration Page 196
0C LAN ERROR -
RECEIVER OFF
There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists after the printer
is turned on again, there is a problem with the HP Jetdirect
print server.
0D LAN ERROR -
TRANSMITTER OFF
There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists, there is a
problem with the HP Jetdirect print server.
0E LAN ERROR -
LOSS OF CARRIER
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect
print server.
10 LAN ERROR -
UNDERFLOW
(Wired Ethernet) There may be a problem with your network
cabling or the HP Jetdirect print server. Check the cabling
and connectors on your network. If you cannot find a
problem with your network cabling, run the power-on
self-test: turn the printer off, then on again. If the error
persists, there is a problem with the HP Jetdirect print
server.
11 LAN ERROR -
RETRY FAULTS
(Wired Ethernet) There is a problem with your network
cabling or external network configuration. Verify operation
of the hub or switch port.
12 LAN ERROR -
NO LINKBEAT
With a 10/100 Base-TX port connected, this message is
displayed if Link Beat is not sensed. Check the network
cable, and verify that the concentrator/hub is providing Link
Beat.
13 NETWORK
RECONFIG - MUST
REBOOT
Reset or power off/on the HP Jetdirect print server to enable
new configuration values.
14 DISCONNECTED The Novell NetWare protocol is disconnected. Check the
server and the print server.
15 CONFIGURATION
ERROR
(Ethernet) The configuration information for the NetWare
functions is not stored correctly on the HP Jetdirect print
server. Use the installation software, embedded Web
server, or other tools to reconfigure the print server. If this
error persists, there may be a problem with the HP Jetdirect
print server.
Table 9.9 Error Messages (2 of 10)
Error Code and
Message
Description