Filter
Top Products
ENWW TCP/IP Configuration 85
Other
Command Description
link-type (10/100 Fast Ethernet) Sets the print server’s link speed (10
or 100 Mbps) and communication mode (Full- or
Half-Duplex). Selections are AUTO, 100FULL, 100HALF,
10FULL, 10HALF.
For AUTO (default), the print server uses autonegotiation to
determine the link speed and mode. If autonegotiation fails,
then 100HALF is set.
laa Specifies a locally administered address (LAA) that replaces
the factory-assigned LAN Hardware (MAC) address. If LAA
is used, a user-specified string of exactly 12 hexadecimal
digits must be entered.
For Ethernet print servers, the LAA address must start with
hexadecimal X2, X6, XA, or XE, where X is any hexadecimal
digit 0 through F.
The default address is the factory-assigned address.
scan-idle-timeout Specifies the number of seconds (1 - 3600) that an idle scan
connection is allowed to remain open. 0 disables the
timeout. The default is 300 seconds.
MFP-config (MFP config) Enable or disable print server support of the
client software provided with your multifunction or all-in-one
peripheral.
0 (default): disables client software support (allows printing
only).
1: enables client software support (allows printing and
scanning).
Support
Command Description
Web JetAdmin URL (Read-only parameter) If HP Web Jetadmin discovers this
device, the URL to access HP Web Jetadmin will be
specified.
Web JetAdmin
Name
(Read-only parameter) If HP Web Jetadmin discovers this
device, the name of the HP Web Jetadmin host will be
specified (if known).
support-name Typically used to identify the name of a person to contact for
support of this device.
support-number Typically used to specify a phone or extension number to
call for support of this device.
support-url A Web URL address for product information on this device
over the Internet or an intranet.
tech-support-url A Web URL address for technical support over the Internet
or an intranet.
Table 3.4 Telnet Commands and Parameters (13 of 13)