Filter
Top Products
ENWW The HP Jetdirect Control Panel Menu 219
PING TEST This test is used to check network
communications. This test sends link-level
packets to a remote network host, then waits
for an appropriate response. To run a ping
test, set the following items:
● DEST IP: Specify the IP address of the
remote host. A valid IP address must be
entered. For example, 0.0.0.0 is not
allowed.
● PACKET SIZE: Specify the size of each
packet, in bytes, to be sent to the remote
host. The minimum is 64 (default) and the
maximum is 2048.
● TIMEOUT: Specify the length of time, in
seconds, to wait for a response from the
remote host. The default is 1 and the
maximum is 100.
● COUNT: Specify the number of ping test
packets to send for this test. Select a
value from 1 to 100. To configure the test
to run continuously, select 0.
● PRINT RESULTS: If the ping test was not
set for continuous operation, you can
choose to print the test results. Select
YES to print results. If you select NO
(default), results will not be printed.
● EXECUTE: Specify whether to initiate the
ping test. Selet YES to initiate the test, or
NO to not run the test.
Table B.1 HP Jetdirect Control Panel Menu (5 of 7)
Menu Item Options Description of settings