Filter
Top Products
ENWW HP Jetdirect Configuration Page 203
52 BAD BOOTP/DHCP
REPLY
An error was detected in the BOOTP or DHCP reply that the
HP Jetdirect print server received. The reply either had
insufficient data in the UDP datagram to contain the
minimum BOOTP/DHCP header of 236 bytes, had an
operation field that was not BOOTPREPLY(0X02), had a
header field that did not match the print servers hardware
address, or had a UDP source port that was not the
BOOTP/DHCP server port (67/udp).
53 BAD BOOTP
TAG SIZ E
The tagsize in a vendor-specific field in the BOOTP reply
is either 0, or greater than the remaining number of
unprocessed bytes in the vendor-specified area.
54 BOOTP/RARP
IN PROGRESS
The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/RARP.
55 BOOTP/DHCP
IN PROGRESS
The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/DHCP, and has not detected any errors.
56 DHCP NAK The HP Jetdirect print server received a negative
acknowledgement message from the DHCP server in
response to a configuration request.
57 UNABLE TO
CONNECT DHCP SVR
The HP Jetdirect print server had received IP parameters
from a DHCP server, but communication with the DHCP
server has been lost. Check status of the DHCP server.
If an infinite lease was assigned, the print server will use the
IP address of the most recent DHCP server used, but
operation may be degraded until a DHCP server responds.
58 POSTSCRIPT
MODE NOT
SELECTED
The printer does not support AppleTalk or AppleTalk
extensions.
59 INCOMPLETE F/W -
MUST DOWNLOAD
Firmware download message. Currently downloading
firmware to the HP Jetdirect print server, or the download
did not complete properly.
5A TURN PRINTER
OFF / ON
Firmware download message. Download of firmware is
complete. Power off/on the HP Jetdirect print server.
5C DHCP BAD REPLY A bad reply was received from the DHCP server. Check your
DHCP server settings for this print server.
5D DHCP LEASE
DURATION TOO
SHORT
The DHCP lease times for this print server’s TCP/IP
configuration settings are too short. Reconfigure the DHCP
lease times on the DHCP server.
Table 9.9 Error Messages (9 of 10)
Error Code and
Message
Description