Filter
Top Products
ENWW TCP/IP Configuration 88
Using Telnet to Erase the Existing IP Settings
To erase the IP address during a Telnet session, use the following
command line entries:
1. Type cold-reset, then press Enter.
2. Type quit, then press Enter to exit Telnet.
3. Power the print server off/on.
Note This procedure resets all TCP/IP parameters, but
only affects the TCP/IP subsystem. Parameters for
other subsystems such as IPX/SPX or AppleTalk are
not affected.
To reset all parameters to factory default values,
refer to Chapter 8
.
Using the Embedded Web Server
You can set IP parameters on HP Jetdirect print servers that
support the embedded Web server. For more information, refer to
Chapter 4
.