Filter
Top Products
ENWW TCP/IP Configuration 83
IPX/SPX
Command Description
ipx-config Enables or disables IPX/SPX protocol operation on the print
server. 0 disables, 1 (default) enables. For example,
ipx-config 0 will disable IPX/SPX operation.
ipx-unitname (Print Server Name) A user-assigned alphanumeric name
assigned to the print server (31 characters maximum). By
default, the name will be NPIxxxxxx, where xxxxxx are the
last six digits of the LAN hardware address.
Address (Read-only parameter) Identifies the IPX network and node
numbers detected on the network, in the form
NNNNNNNN:hhhhhhhh (hexadecimal), where
NNNNNNNN is the network number and hhhhhhhh is the
LAN hardware address of the print server.
ipx-frametype Specifies the IPX frame type settings available for your print
server model: AUTO (default), EN_SNAP, EN_8022,
EN_8023, EN_II, TR_8022, TR_SNAP. For more
information, see Chapter 9
.
ipx-sapinterval Specifies the time interval (1 to 3600 seconds) that the
HP Jetdirect print server waits between Service Advertising
Protocol (SAP) broadcasts on the network. The default is
60 seconds. 0 disables SAP broadcasts.
ipx-mode (Read-only parameter) Specifies the NetWare mode
configured on the print server, eith RPRINTER or
QSERVER mode.
ipx-nds-tree An alphanumeric string, up to 31 characters, that specifies
the NDS tree name for the print server.
ipx-nds-context An alphanumeric string, up to 256 characters, that specifies
the NDS context for the HP Jetdirect print server.
ipx-job-poll Specifies the time interval (1 to 255 seconds) that the
HP Jetdirect print server will wait to check for print jobs in
a print queue. The default is 2 seconds.
pjl-banner
ipx-banner
Enables or disables printing an IPX banner page through
Printer Job Language (PJL). 0 disables banner pages. 1
(default) enables banner pages.
pjl-eoj
ipx-eoj
Enables or disables IPX end-of-job notification through PJL.
0 disables, 1 (default) enables.
pjl-toner-low
ipx-toner-low
Enables or disables IPX toner-low notification through PJL.
0 disables, 1 (default) enables.
Table 3.4 Telnet Commands and Parameters (11 of 13)