Filter
Top Products
HP OmniBook 2100/3000/3100 Removal and Replacement 2-7
On any computer that has a CD-ROM drive, run makesupp from the
\Omnibook\Drivers\Hputils directory on the OmniBook Recovery CD.
On any computer with World Wide Web access, download the Support Utility software
package from the OmniBook website (see page vi). Follow the instructions provided.
2. Insert the Recovery CD in the CD-ROM drive—or insert the Support Utility disk in the floppy
drive.
3. Reboot the computer. If you are using the Recovery CD, press ESC during reboot if the
OmniBook screen appears, ESC to display the boot-device menu, then select the CD-ROM drive
as the boot device.
4. When prompted, select “Create Hibernate Partition.”
OmniBook 2100/3100: We recommend that you create a partition the same as the factory setup—
288 MB for a Pentium II CPU, or 192 MB for a Pentium CPU (160 MB is acceptable if the
motherboard has only one RAM slot).
OmniBook 3000: We recommend that you create a 144-MB partition, the same as the factory
setup.
Removing a RAM Board
(User-Replaceable)
Table 2-5. RAM Board Replacement Part Numbers and Compatibility
Description Part Number Exchange OmniBook, CPU Type, RAM Slots
Part Number 2100
Pentium II
2100/3100
Pentium
3000
Pentium
Inner Corner
Slot Slot
Inner Corner
Slot Slot *
Inner Corner
Slot Slot
RAM, 32-MB SDRAM 1818-7413 F1456-69001
• • • •
RAM, 64-MB SDRAM 1818-7414 F1457-69001
• • •
RAM, 128-MB SDRAM 1818-7549 F1622-69001
• • •
RAM, 16-MB EDORAM F1363-60001 F1363-69001
o o
• •
RAM, 32-MB EDORAM F1364-60001 F1364-69001
o o
• •
RAM, 64-MB EDORAM F1365-60001 F1365-69001
o
• •
• Recommended compatibility.
o
Alternate compatibility. Do not mix SDRAM and EDORAM boards in two slots.
To determine the CPU type, see the Intel sticker on the top case or see the picture showing the CPU modules on
page 2-25.
* The corner RAM slot is not present on an OmniBook 2100/3100 with a Pentium CPU and one-slot
motherboard.
Caution
Handle the RAM board only by its edges and provide proper grounding. Otherwise, you may
damage the board due to electrostatic discharge.
Required Equipment
• Small Phillips screwdriver.