Filter
Top Products
EN The PCL Print Model 5-43
Set Pattern Reference Point Command
The Set Pattern Reference Point command causes the printer to tile
patterns with respect to the current cursor position (CAP). This
command also specifies whether the pattern rotates with the print
direction or remains fixed.
? * p # R
A value field of 0 rotates the patterns with changes in the print
direction (see Print Direction command). For a value field of 1,
patterns remain fixed for changes in print direction.
The default pattern reference point is the upper left corner of the
logical page at the top margin (position 0,0). If the Set Pattern
Reference Point command is not set, the pattern is tiled with respect
to the default reference point.
Note All patterns are rotated for changes in orientation, but the pattern
reference point remains the same (refer to “Logical Page Orientation
Command” in Chapter 5 of the PCL 5 Printer Language Technical
Reference Manual).
This command applies to user-defined, shading, and cross-hatch
patterns.
# = 0 - Rotate patterns with print direction
1 - Keep patterns fixed
Default =0
Range = 0,1 (values outside the range are ignored)