Filter
Top Products
EN The PCL Print Model 5-29
Pattern ID (Area Fill ID) Command
The Pattern ID command (formerly called Area Fill ID) identifies the
specific shading, cross-hatch, or user-defined pattern. (This
command is also used for rectangular area fill, described later in this
chapter.)
? * c # G
For rectangular areas, the pattern “material” is determined by both
the pattern ID and the value of the Fill Rectangular Area command.
For other images, the pattern material is determined by the pattern ID
and the value of the Select Pattern command.
Figure 5-7 and Figure 5-8 illustrate the HP-defined shading patterns
and cross-hatched patterns, respectively.
Note This command is used for both the Select Pattern and Rectangular
Area Fill graphics.
For user-defined patterns, this command, sent prior to downloading a
user-defined pattern, assigns an ID pattern number to the
downloaded pattern. (For more information, see “User-Defined
Pattern Graphics,” later in this chapter.)
Selecting Shaded patterns: Selecting Cross-Hatch
patterns:
# = 1 thru 2 = 1- 2% shade # = 1 - Pattern #1
3 thru 10 = 3-10% shade 2 - Pattern #2
11 thru 20 = 11-20% shade 3 - Pattern #3
21 thru 35 = 21-35% shade 4 - Pattern #4
36 thru 55 = 36-55% shade 5 - Pattern #5
56 thru 80 = 56-80% shade 6 - Pattern #6
81 thru 99 = 81-99% shade
100 = 100% shade
Selecting User-Defined patterns:
1
# = ID number of user-defined pattern
1
Not supported on all PCL 5 printers. Refer to the “PCL Feature Support Matrix” in
Chapter 1 of the PCL 5 Comparison Guide for specifics.
Default = 0 (no pattern)
Range = 0 – 32767 (values outside the range are ignored)