Filter
Top Products
EN Raster Graphics 6-37
Destination Raster Width
The Destination Raster Width command defines the width in
decipoints of the destination raster picture denoted by the next Start
Raster command, which must have a value field of 2 or 3 (
?*r2A or
?*r3A).
? * t # H
Zero or absent values default the destination width to a value that
preserves isotropic scaling.
A specified width that would cross the right physical page boundary is
clipped at the right physical page boundary, but the scale factor is
maintained.
Destination Raster Height
The Destination Raster Height command defines the height in
decipoints of the destination raster picture denoted by the next Start
Raster command, which must have a value field of 2 or 3 (
?*r2A or
?*r3A).
? * t # V
Zero or absent values default the destination height to a value that
preserves isotropic scaling.
A specified height that is longer than the physical page is clipped at
the bottom of the physical page, but the scale factor is maintained.
# = Width (in decipoints)
Default = Right logical page boundary minus left graphics margin
Range = 0 – 32767.0000 (values outside the range are ignored)
# = Height (in decipoints)
Default = Bottom logical page boundary minus vertical CAP
Range = 0 – 32767.0000 (values outside the range are ignored)