Filter
Top Products
3.3 HALTING A SCAN SEQUENCE
To halt a scan sequence, the operator must have selected the monitor running that scan
sequence.
When the
key is pressed, the message:
will be displayed. The last camera selection made by the scan sequence will remain
displayed on the monitor.
To restart a previously halted scan sequence, press the
key followed by the
key. A number is not required.
• for example, .. restarts the last scan sequence halted for
this monitor.
If the monitor is already running a scan sequence before manually selecting a camera
(or a different scan sequence), then the following message appears:
Rev. A 3-3 HMXMU001056
03/16/05