Filter
Top Products
3.6 EDITING A SCAN SEQUENCE
, Access denied to some operators
To edit a scan sequence it is necessary for the desired sequence to be selected to the
operator's monitor.
for example, .. selects scan sequence 20,
and starts it scanning.
Press the key to pause the scan sequence.
Now, press the
key. The message:
will be displayed. The 'SET SCAN' mode is now enabled and the operator can begin to
edit the scan sequence.
Use the
and keys to move backwards and forwards in the scan sequence
entry list.
When the required entry position has been selected, then one of the following three
operations can be performed:
3.6.1 Overwrite With A New Camera Selection
Simply make another camera selection. This will overwrite the current entry in the scan
sequence list.
For example suppose that the second entry needs to be camera number 25 instead of
camera number 12.
Entry position in Scan Sequence 1 2 3 4 5
Camera No. 2 12 29 14 17
Entry position selected
*
Table 3.2: Entry Positions In Scan Sequence 20 Before Overwriting.
Rev. A 3-8 HMXMU001056
03/16/05