Filter
Top Products
CHAPTER 10:
TROUBLESHOOTING
10.1 SELECTING A CAMERA
1. Check that you have first selected a monitor for use. The keyboard identity or your
operator name should be displayed in the text on the monitor you are currently
selecting.
2. Are you using the correct number of digits for the camera selection number? Try
using the
key to complete your camera selection number.
3. In case your number entry is offset by a digit or two, try pressing the
key
again to begin a new camera selection number.
4. Is the monitor scanning? You cannot manually select a camera to a monitor that is
running a scan sequence or tour sequence. If so, halt the scan sequence then try
selecting the camera again.
5. Note the message prompts displayed on the monitor when you attempt to select the
camera. Refer to the Section 'Message Prompts' in this manual for more information.
:
Rev. A 10-1 HMXMU001056
03/16/05