Filter
Top Products
4.3 MAKE A NEW MACRO, CONTINUED
The system will now begin recording operator keyboard actions. These may be recorded
in a REALTIME mode whereupon running of the macro the operator actions will be
played back with the same timing with which they were recorded, or in AUTO-TIMING
mode whereupon operator actions will be played back automatically timed. The
recording mode may be toggled during recording by pressing the
key. The
prompt:
or
will then be displayed briefly to indicate the current mode.
NOTE: To redefine a macro that has been used
previously, it must first be deleted. Refer to the following
section DELETE A MACRO.
To end the recording, press the
key again. The message prompt:
will be displayed briefly.
Your macro is now defined with the recorded keystrokes. Now, test the MACRO to see if
it executes correctly.
The newly defined macro will be saved back onto disk automatically by the system after
30 seconds of inactivity or by initiating a ’Save Now’ function from System Macros.
Rev. A 4-4 HMXMU001056
03/16/05