Filter
Top Products
Enabling Epson Emulation
To enable emulation of an Epson single-station printer on a single-station SureMark
printer, you must set switch 3 on the main logic card. See Figure 15.
Limitations for Epson Emulation
The following limitations must be considered when using the SureMark printer to
emulate an Epson single-station printer.
v Logos and downloadable characters are supported in emulation mode. However,
because the Epson printer prints at 150 dpi and the SureMark prints at 200 dpi,
the emulated printout will be smaller.
v Emulation of page mode is not supported on the SureMark.
v Epson supports the Select paper sensor to stop printing command. IBM does not
support a low paper sensor.
Changing the Printer Mode between DBCS and SBCS
To disable DBCS printing (that is, to enter SBCS mode), use the 4610 DBCS
Installation Utility Diskette.
Note: This procedure requires 4610 DBCS Installation Utility Diskette V1.00 or
later.
1. Insert the 4610 DBCS Installation Utility Diskette in drive A.
2. Power on the system unit.
3. Select Change Printer Mode when the menu is displayed.
4. Perform the specified steps to change the printer mode.
To set to DBCS Mode:
a. Select DBCS Mode.
b. Press Ctrl-Alt-Delete to reboot the system. The system IPLs.
To set to SBCS Mode:
a. Select SBCS Mode.
1
2
3
OFF
4
RS-232 mode switches
Cash drawer connector
Figure 15. Switch for Epson Emulation
updated March 18, 2002
42 SureMark DBCS User’s Guide