Filter
Top Products
Datasheet 93
Signals Reference
For memory or I/O transactions, the byte-enable signals indicate that valid data is requested or
being transferred on the corresponding byte on the 128-bit data bus. BE[0]# indicates that the least
significant byte is valid, and BE[7]# indicates that the most significant byte is valid. Since
BE[7:0]# specifies the validity of only 8 bytes on the 16 byte wide bus, A[3]# is used to determine
which half of the data bus is validated by BE[7:0]#.
For special transactions ((REQa[5:0]# = 001000B) and (REQb[1:0]# = 01B)), the BE[7:0]# signals
carry special cycle encodings as defined in Table A-3. All other encodings are reserved.
For Deferred Reply transactions, BE[7:0]# signals are reserved. The Defer Phase transfer length is
always the same length as that specified in the Request Phase except the Bus Invalidate Line (BIL)
transaction.
A BIL transaction may return one cache line (128 bytes).
A.1.9 BERR# (I/O)
The Bus Error (BERR#) signal can be asserted to indicate a recoverable error with global MCA.
BERR# assertion conditions are configurable at the system level. Configuration options enable
BERR# to be driven as follows:
• Asserted by the requesting agent of a bus transaction after it observes an internal error.
• Asserted by any bus agent when it observes an error in a bus transaction.
When the bus agent samples an asserted BERR# signal and BERR# sampling is enabled, the
processor enters a Machine Check Handler.
BERR# is a wired-OR signal to allow multiple bus agents to drive it at the same time.
Table A-3. Special Transaction Encoding on Byte Enables
Special Transaction Byte Enables[7:0]#
NOP 0000 0000
Shutdown 0000 0001
Flush (INVD) 0000 0010
Halt 0000 0011
Sync (WBINVD) 0000 0100
Reserved 0000 0101
StopGrant Acknowledge 0000 0110
Reserved 0000 0111
xTPR Update 0000 1000