Filter
Top Products
MPCBL0010 SBC—Hardware Management Overview
Intel NetStructure
®
MPCBL0010 Single Board Computer
Technical Product Specification October 2006
120 Order Number: 304120
0x46
Management Subsystem
Health
FRU1 Sensor Err IPMC Yes N/A
0x47 Power Supply FRU2 Mp Over Icc FPGA Yes N/A
0x48 Power Supply FRU2 Over Icc FPGA Yes N/A
0x49
Management Subsystem
Health
FRU2 Sensor Err IPMC Yes N/A
0x4A Platform Alert FRU0 Pwr Denied IPMC Yes N/a
0x4B Platform Alert FRU1 Pwr Denied IPMC Yes N/A
0x4C Platform Alert FRU2 Pwr Denied IPMC Yes N/a
Table 110. OEM Sensor Types
OEM Name OEM Number Description
OEM Firmware
Information
COh
Sensor indicates information about firmware state. According to the
Event/Reading Type, the 2 first bits will have assertion mask set.
Associated event/reading type code:
• 0x70-OEM Firmware Info 1
• 0x71-OEM Firmware Info 2
• 0x75-OEM Firmware Info 2
Init Agent
Sensor
C2h
Display the last error that occur in the RunInitAgent.
Associated event/reading type code:
• 03h - IPMI Digital discrete
IPMBL Link
State
C3h
Sensor indicates the status of the 3rd IPMB link named L. This sensor
matches the AdvancedTCA defined type F1h
(SDR_SENSTYPE_ATCA_PHYSICAL_IPMB0). See AdvancedTCA
specification ECN 3.0 1.0 001 section 3.8.4 for details related to this
sensor. An OEM sensor type is used because the type is reserved for Port
Link A & B. Sensor Port Link L do not include a port B and Port L is placed
at the same location as IPMB A. All bytes related to IPMB B are set to
"enable-working" state. The sensor will only move from state (byte 4 in
Get Sensor reading command):
[3] 1b = IPMB A enabled, IPMB-B enabled to
[2] 1b = IPMB A disabled, IPMB-B enabled
A value of 1 and 0 is not possible.
This sensor matches the AdvancedTCA defined type F1h.
AdvancedTCA
Reset Sensor
C4h
Sensor indicates board reset source. All defined bits will have assertion
event mask set.
Associated event/reading type code:
• 6Fh IPMI Sensor Specific
FIA Error
Sensor
C5h
Sensor indicates if there as been an error during the FRU Information
Agent scan (used for E-Keying).
Associated event/reading type code:
0Ah - DMI-based availability
POST Value
Sensor
C6h
Sensor indicates BIOS POST error code.
Associated event/reading type code:
• 6Fh - IPMI Sensor Specific
FWUM Status C7h
Sensor indicates the state of the Firmware Update Manager (for rollback).
Associated event/reading type code:
• 6Fh OEM FWUM Status
Table 109. Hardware Sensors (Sheet 4 of 4)
Sensor
Number
Sensor Type
Sensor Name
(Signal Monitored)
Monitored
Via
Scanning
Enabled in
Power-Off
State (M1)
Health LED
(Green to Red)