Filter
Top Products
ZT8101 User’s Manual 19
Installation and Initial Setup
2. To configure the IP address, use the Arrow keys or the Tab key to modify the settings in the
New Switch IP Settings column.
3. To configure a name and contact information for the switch, enter information in the following
fields.
4. Highlight APPLY and press Enter.
5. Press Escape to return to the Main Menu.
6. To save your changes to NV-RAM, highlight Save Changes and press Enter.
To continue configuring the switch, see chapter 4 for information on this interface. See chapter 5
for information about using the Web Console.
Upgrading Firmware through Zmodem
Generally, TFTP is the first choice to use to upgrade firmware. The Telnet Console and the Web
Console both have options for upgrading the firmware using a TFTP server (see chapters 4 and 5).
However, you can also use Zmodem to upgrade the firmware from the serial port.
Note: If FLASH becomes corrupted because you lose power when upgrading the firmware, you must use
Zmodem to fix the problem.
To upgrade the firmware using Zmodem
1. Obtain the runtime firmware.
2. Using Windows HyperTerminal*, log in to the switch through the serial port.
3. From the Main Menu, select Reboot and press Enter.
Parameter Default Description
Get IP From Manual
Specifies the method for assigning the switch an IP address.
Use the spacebar to toggle to Manual, DHCP, or BOOTP.
IP Address 10.90.90.90 Specifies the IP address assigned to the switch.
Subnet Mask 255.0.0.0
Specifies the subnet mask assigned to the switch and to the
other devices on this segment of the network.
Default Gateway 0.0.0.0
Specifies the IP address of the device that routes to different
networks. A gateway must be defined if the workstation you
are going to use for switch management is located on a
different IP segment than the switch.
VLAN Name default
Specifies the name of the VLAN that contains the
workstations that you will use to manage the switch. This
VLAN must already exist.
Parameter Description
Name
Specifies the name assigned to the switch. If you are installing multiple
switches, you should give each a unique name.
Location Specifies the physical location of the switch.
Contact Specifies the name of the person responsible for the switch.