Filter
Top Products
DataSafe NAS User’s Manual 31
Figure 8 DNS Configuration
5. Next to the Configuration option, select the
Obtain configuration from DHCP server
radio button.
6. Click OK.
To manually set the DNS servers to be used by
the DataSafe NAS
1. On the primary menu bar, click Network Setup.
2. On the Network Setup page, click Interfaces.
3. From the Object Selection table, select the
network connection to modify.
4. On the Tasks list, select DNS.
5. Next to the Configuration option (see Figure 8
on page 31), select the Configure manually
radio button.
6. Enter the appropriate server name in the box next
to the Add button, then click Add.
7. To add another DNS server, repeat step 5.
8. When you are finished adding DNS servers, click
OK.
Note: If the IP address is set to be obtained from
DHCP, and you set DNS manually, the system
will accept the manual input, and the
properties on the DataSafe NAS will
automatically be set to Configure
manually. However the Current
Configuration column of the Object
Selection table on the Network Adapters
page will still show DHCP as the source of the
IP address. You can go back into the DNS
settings properties page to confirm that the
manual configuration has been saved.