DataSafe NAS User’s Manual 1
About This Guide
Who Should Use This Guide
This DataSafe NAS User’s Manual is intended to help
setup, configure, and maintain DataSafe NAS. It
assumes that you are somewhat familiar with
networking and system administration basics.
Overview
Your DataSafe NAS comes ready to install with all the
required software. It works in a 10/100 Mbps Ethernet
network (or Gigabit Ethernet network when so
equipped), and is administered using an Internet
Explorer web browser. It includes DataSafe Wizard,
Iomega’s software utility that helps you locate the unit
on your network, configure DataSafe NAS network
settings, and launch the web user interface.
Equipment Required for Administration
To connect, install and administer your DataSafe NAS,
you will need an available 10/100 Ethernet network
hub or switch. It will also be necessary for your
workstation to have the following capabilities:
n Windows 95/98/Me/NT (SP5)/2000
n Internet Explorer v4.01 SP1 or newer - support for
Netscape is not currently available.
n Client for Microsoft Networks enabled over TCP/IP.
n Network Interface Card (NIC)
n CD-ROM Drive