Filter
Top Products
3 - 5
A-41069 January 1993
5. Turn the Gap Adjustment Knob clockwise three complete turns to
open the gap between the feed and separator rollers.
6. Select two documents of the same size, texture and thickness,
similar to the types of documents you will be processing.
7. Place one document on top of the other. Hold them firmly by their
trailing edges. Insert them into the gap approximately 0.125 (1/8)
inch (3 mm).
If the documents separate, repeat the following steps until the
documents do not separate:
a. Turn the Gap Adjustment Knob clockwise one-half (1/2) turn.
b. Insert the documents again.
If the documents do not separate, proceed with Step 8.
8. Rotate the Gap Adjustment Knob counterclockwise one or two
clicks.
9. Hold the trailing edges of the documents firmly. Insert them into the
gap.
If the bottom document is not separating from the top document,
remove the documents and repeat Steps 8 and 9 until the bottom
document separates from the top document.
If the bottom document is separating from the top document,
proceed with Step 10.