Filter
Top Products
A-41069 January 1993
6-6
Code Operator Message Displayed Description/Action Required
E283 Invalid configuration for OCR OCR is not enabled in the mode selected.
Enable the OCR using function code F76, or
change the application mode to one in which the
OCR is enabled.
E284 OCR initializing - please wait System is busy.
Wait until the message clears and continue.
E285 Feeder off due to OCR request System is busy.
Feeder will be reactivated when the system is no
longer busy.
Wait until the message clears and continue.
E286 Feed calibration target Calibration process has started.
Press the Run key and feed the calibration target
into the transport.
E288 OCR batch stopped due to error Determine the cause of the error via the OCR
Workstation interface.
Correct the error. Rerun the batch.
E291 Scanner disabled The machine has been disabled due to an error.
Determine the cause of the error via the host
system.
Enable the machine.
Press the Run key to continue.
E293 Host recovery required Contact your System Administrator to initiate the
required action on the host system.
E294 Front calibration warning Perform maintenance/cleaning procedures for the
Document Scanning Array, Image Guides, etc.
Check the lamps; replace if necessary.
Recalibrate the machine.
E295 Rear calibration warning Perform maintenance/cleaning procedures for the
Document Scanning Array, Image Guides, etc.
Check the lamps; replace if necessary.
Recalibrate the machine.
E296 Target not seen Repeat the calibration process using a blank target.
If error repeats, call service.
E297 Document que full The feeder and transport are stopped, and the
machine is disabled.
Transfer images from the image buffer to the
host system.
Re-enable the machine.
Press the Run key to continue.
E298 Calibration required Enter function code F37 to initiate the calibration
sequence.