Filter
Top Products
3 - 8 A-41069 January 1993
Adjusting the feed shelf
side guides
Before you begin processing documents, adjust the side guides on the
feed shelf to accomodate the documents being processed.
2. Slide apart the Side Guides on the Feed Shelf until the Feed Shelf
Label is visible.
Center line
2. Center the documents across the feed shelf label. Adjust the feeder
side guides dependent upon the width of the document. Leave
approximately 0.0625 (1/16) inch (2 mm) clearance on each side of
the documents so that they will feed properly.
NOTE: If the documents are larger than the area shown on the
Feed Shelf Label and do not fit between the Side Guides,
rotate and reposition the documents within the Side Guides.