Filter
Top Products
4 - 3
A-41069 August 1995
Feeding documents
After the Scanner has been prepared for operation and the desired
mode and any temporary operating values have been defined, you are
ready to feed documents into the transport.
1. Verify that the side panel switch is on. Also verify that all of the
proper adjustments have been made (feeder side guides, exit
hopper side guides, etc.).
2. Press the Run key.
3. Select a stack of documents which is no more than 1.5 inch thick.
4. Fan the stack of documents so that the leading edge of the top
document will engage the feed/separator rollers first (refer to the
illustration above).
5. Place the stack of fanned documents into the feeder so that the
leading edge of the top document contacts the feed/separator
rollers. The documents will be drawn into the transport, with the top
document being fed first. The documents will be deposited in the
exit hopper face down, in the order in which they were fed into the
transport.
6. Repeat steps (3) through (5) until all of the application documents
have been fed into the transport.
7. Press the Stop key after all documents have been deposited in the
exit hopper.