Filter
Top Products
A-41069 January 1993
6-3
Code Operator Message Displayed Description/Action Required
E121 Check front patch reader Patch code not recognized.
E122 Check rear patch reader Verify that the patch document was fed into the
transport in the proper orientation.
If not, refeed the patch document.
If so, change to a non-patch mode to continue;
call service.
E123 Command data rejected - resend Command not recognized. Enter command again.
E124 Command not allowed in this model Command cannot be performed.
E125 Enter a valid command.
E126 Enter correct command Press correct key(s) for mode selected.
E127 Feeder waiting for host system System is busy. No action required.
Wait for message to clear.
E128 Feeder adjustment warning Check and adjust feed and separator roller gap.
E130 OCR not installed Requested action requires installation of the OCR
accessory.
E131 Device not enabled Requested action requires installation of the Bar
Code Reader.
E132 Enable barcode first Requested action requires that you enable the
E133 Bar Code Reader.
Enter function code F60 to enable bar code reading.
E140 Document Printer not installed Requested action required installation of the
E141 Patch Reader not installed module/accessory indicated.
E142 Detection System not installed The required module/accessory is not installed.
E143 Barcode Reader not installed
E145 Endorser not installed