Filter
Top Products
5-5. AppleTalk Configuration
101 II Network Setup - Administrators only
Chapter 5 Web Utility
Changing AppleTalk Settings
The following AppleTalk Settings may also be changed:
Printer Name
This is the printer (network interface card) name used on the AppleTalk network. The default name is
KC******(last 6 letters of the MAC address).
● You may not use the following symbols in the printer name: (, ), *, @, -, =, :
Zone Name
The zone in which the network interface card resides is displayed here. Leave this blank if no zone is
created as when using networks that have no seed routers. Printing will not start unless the zone name
is designated correctly.
To alter any of the AppleTalk settings, follow these steps:
1 Open the AppleTalk Configuration page.
2 In the AppleTalk Settings section, select the field you wish to change.
3 Enter the new settings.
4 At the bottom of the page, type in the system password in the provided field.
5 Click [Apply].
● Changes do not take effect until you start the copier. Be sure to wait at least 10 seconds after turning off
the main power switch before you turn the copier back on.