Filter
Top Products
Default Setting (System Menu)
OPERATION GUIDE 8-85
8
Send Result Report
Automatically print a report of transmission result when a transmission is complete. The table below shows the
available settings. The default setting is Error Only.
Use the procedure below to send a Result Report.
1 In the Sys. Menu/Count. menu, press the U or V
key to select [Report].
2 Press the OK key. The Report menu appears.
3 Press the U or V key to select [Result Rpt Set.].
4 Press the OK key. The Result Rpt Set. menu
appears.
Item Description
Off No result report printed.
On Result report automatically printed.
Transmitted images can also be attached.
Error Only Result report printed only when a
transmission ends in an error. If two or
more destinations are registered, the
reports are printed only for the destinations
with the errors. Transmitted images can
also be attached.
Sys. Menu/Count.:
a
b
*********************
2
Counter
3
System
[ Exit ]
1
Report
Report:
a
b
*********************
2
Admin Rpt Set.
3
Result Rpt Set.
[ Exit ]
1
Report Print
Result Rpt Set.:
a
b
*********************
2
FAX RX Result
3
JobFinish Notice
[ Exit ]
1
Send Result