Filter
Top Products
3: Installation of PremierWave XC
PremierWave XC User Guide 20
Back Panel
On the PremierWave XC back panel, there is a Barrel Connector for Primary Power (Power 1), 3-
Pin Terminal Connector for Secondary Power (Power 2), USB 1, USB 2, RJ-45 Ethernet Port and
Reset button as shown in Figure 3-5.
Figure 3-5 PremierWave XC Back Panel View
The Ethernet Port has two LEDs that indicate the status of the connection as follows:
Left LED
- Green ON 100 Mbps Link
- Green Blink 100 Mbps Activity
- Amber ON 10 Mbps Link
- Amber Blink 10 Mbps Activity
Right LED
- Green ON Full Duplex
- OFF Half Duplex
The Ethernet port can connect to an Ethernet (10 Mbps) or Fast Ethernet (100 Mbps) network.
Reset Button
You can reset the PremierWave XC to factory defaults, including clearing the network settings.
The IP address, gateway, and netmask are set to 00s. To reset the unit to factory defaults,
perform the following steps.
1. Place the end of a paper clip or similar object into the Reset button opening and hold down for a
minimum of 10-15 seconds.
2. Remove the paper clip to release the button. The unit will continue the boot process restoring it back to
the original factory default settings.