Filter
Top Products
PremierWave XC User Guide 34
6: Network Settings
The PremierWave XC contains two network interfaces. The Ethernet interface is also called
Network 1 or eth0, and the Cellular interface is called Network 2 or wwan0.
The Network Settings show the status of the Ethernet
or Cellular interface/link and let you
configure the settings on the device. Interface settings are related to the configuration of the IP
and related protocols. Link settings are related to the physical link connection, which carries the
respective network traffic.
Notes:
Some settings require a reboot to take effect. These settings are noted below.
The blue text in the XML command strings of this chapter are to be replaced with a user-
specified name.
WAN Connection Settings
Table 6-1 shows the settings for the Wide Area Network (WAN) that can be configured.
Table 6-1 WAN Connection Settings
WAN Connection Settings Description
Network
Select Wwan0 or Eth0 to be your default connection.
To Configure WAN Connection Settings
Using Web Manager
To configure WAN Connection settings, click Network in the menu bar and select WAN
Connection.
Using the CLI
To enter the WAN Connection command level: enable -> config → wan
connection
Using XML
Include in your file: <configgroup name=”wan connection”>
DDNS Settings
This section describes the configuration settings for DynDNS (DDNS). You would need an
account with DynDns.com. This would allow the device to connect to a sub-domain with regularly
changing IP address.