Filter
Top Products
6: Network Settings
PremierWave XC User Guide 38
To Configure Network 1 Link Settings
Using Web Manager
To modify Ethernet (eth0) Link information, click Network on the menu and select Network 1
-> Link.
Using the CLI
To enter the eth0 Link command level: enable -> config -> if 1 -> link
Using XML
Include in your file: <configgroup name="ethernet" instance="eth0">
Network 2 Interface Status
To View Network 2 Interface Status
On the Network 2 Interface Status page, you can view the GSM/GPRS status of the device.
To view the Network 2 (wwan0) Status page, click Network on the menu bar and select
Network 2 -> Status.
Network 2 SMS Outbound Settings
The table below shows the settings for SMS Outbound messages and to send a test message.
Table 6-5 Network 2 (wwan0) SMS Outbound Settings
Network 2 (wwan0)
SMS Outbound Settings
Description
SMS Outbound
Select the appropriate SMS format.
Note:
Select the Text ASCII when sending SMS in Text format
(7 bit characters and typically limited to 160 characters per message.)
Select Binary to send SMS in Binary format.
(8 bit characters and typically limited to 140 characters per message.)
Select Unicode to send SMS in Unicode format.
(16 bit characters and typically limited to 70 characters per message.)
Message Center No.
Input the SMS center Number.
Note: This field is required only if the SMS center is incorrect.
Channel
Select the appropriate Channel to send SMS.
Note: The default network setting for transmission of SMS messaging is GSM.
However, there are carriers that support sending of SMS messages over their
GPRS network. Check with your provider.