Filter
Top Products
7: Line and Tunnel Settings
PremierWave XC User Guide 48
Line Command
Mode Settings
Description
Serial String
Enter the Text or Binary string of bytes that must be read on the Serial Line during
boot time in order to enable Command Mode. It may contain a time element to
specify a required delay in milliseconds x, formed as {x}. Applies only if mode is “Use
Serial String”. It may contain a binary character(s) of the form [x]. For example, use
decimal [12] or hex [0xc].
Echo Serial String Select Enabled or Disabled for Echo Serial String. Applies only if mode is “Use
Serial String”. Select enable to echo received characters back out on the line while
looking for the serial string.
Signon Message
Enter the string of bytes to be sent to the Serial Line during boot time. It may contain
a binary character(s) of the form [x]. For example, use decimal [12] or hex [0xc].
To Configure Line Settings
Note: The following section describes the steps to view and configure Line 1 settings;
these steps apply to other line instances of the device.
Using Web Manager
To configure a specific line, click Line in the menu bar and select Line 1 -> Configuration.
To configure a specific line in Command Mode, click Line in the menu bar and select Line 1 -
> Command Mode.
Using the CLI
To enter Line 1 command level: enable -> line 1
Using XML
Include in your file: <configgroup name="line" instance="1">
Include in your file: <configgroup name="serial command mode" instance="1">
Statistics
To View Line Statistics
Using Web Manager
To view statistics for a specific line, click Line in the menu bar and select Line 1 ->
Statistics.
Using the CLI
To view Line statistics: enable -> line 1, show statistics