Lantronix 900-691-R Network Card User Manual


 
11: Monitor
xPico® Wi-Fi® Embedded Device Server User Guide 58
Access the configuration options displayed in Table 11-4 on the Poll page. These configuration
fields are the same ones in Step 3: Define Filters if utilizing Explorer.
Table 11-4 Monitor Poll Settings
Access the configuration options displayed in Table 11-5 on the Filter page. These configuration
fields are the same ones in Step 3: Define Filters if utilizing Explorer.
Table 11-5 Monitor Filter Settings
Poll Settings Description
Message <Number>
Note: In other pages
(Commands/Control
and Poll) in Explorer
or under
Configuration,
additional Message
<Number> fields will
become available to
further filter and
specify the information
you wish to monitor.
Click the Edit link to edit a specific message; this is where a command is entered.
Four message fields will open to allow configuration of a specific command. When
you begin entering information in these fields, additional Message <Number>
options become available containing the four message fields which will also open
upon clicking Edit. Complete the Message <Number> fields:
Command: enter the command in binary format (printable characters or binary
string)
End Character: indicate as a single printable character or as a control character.
Control characters may be input as
<control>J, 0xA (hexadecimal) or \10
(decimal).
Length: set the length of the response.
Timeout: set the timeout length. Minimum timeout length is 100 milliseconds.
Click Submit after making changes to get real time response displayed if you are
utilizing Explorer.
Delay Set the initial delay time in milliseconds before the monitor starts processing the
initialization message. This field appears in Step 1: Setup Initiation.
Filter Settings Description
Rule <Number> Click the Edit link to edit a specific rule. Two rule configuration fields will open for
this rule. When you begin entering information in these fields, additional Rule
<Number> options become available containing the two rule configuration fields
which will also open upon clicking Edit. Complete the Rule <Number> fields:
Source: indicate the input of the filter. For example, if the source of this filter is
the second trunk of data created by filter 1, the source should be set to 1.2. A
Source of 0 indicates the raw response.
Mode: select filter mode (All, Delimiters or Binary)
Delimiter <Number> Binary String: Enter the filter breaks input up to 8 trunks
separated by binary string. Each trunk will not contain the delimiters. This field
appears when Delimiter Mode is selected.
Start index: set to indicate when delimiters filter start breaking input into trunks,
if the Delimiter Mode is selected.
Offset: set the size of the first trunik of data created by the binary filter, if
selected.
Length: set the size of the second trunk of data created by the binary filter, if
selected. The third trunk of data created by the binary filter will contain the rest of
the input.