Filter
Top Products
Appendix A: Command Reference
xPico® Wi-Fi® Embedded Device Server User Guide 79
configitem Access Control
value URI
The URI must begin with
/ to refer to the file system.
URI may contain up to 255 characters.
value AuthType
The different AuthType values offer various levels of security. From the least to most secure:
None
no authentication necessary
Basic
encodes passwords using Base64
There is no real reason to create an authentication directive using None unless you want to override a
parent directive that uses some other AuthType.
AuthType may be "None" or "Basic".
value Users
Users may contain up to 54 characters.
configgroup Interface
These settings pertain to the Network Interface on the device. To see the effect of these selections after a
reboot, view the corresponding Status. Changes will take effect after reboot.
When an Access Point is enabled, DHCP Server will assign IP addresses to the access point's clients.
DHCP Server manages up to 4 client IP addresses (only 3 if wlan0 is enabled). The first IP Address will be
the Access Point's IP Address plus one. For example, if the Access Point's IP Address is 192.168.0.1, the
client addresses will range from 192.168.0.2 to 192.168.0.5.
configitem State
value
Enable the State to allow the Interface to operate.
State may be "Enabled" or "Disabled".
configitem DHCP Client
value
If DHCP Client is enabled, any configured IP Address, or Default Gateway will be ignored. DHCP Client
will auto-discover and eclipse those configuration items. Hostname is sent to the remote DHCP Server and
may figure into the address assignment.
When DHCP Client fails to discover an IP Address, a new address will automatically be generated using
AutoIP. This address will be within the 169.254.x.x space.
This setting is not applicable to the Access Point.
DHCP Client may be "Enabled" or "Disabled".