Filter
Top Products
Use To
Job Timeout
0, 10–255 seconds
Set the amount of time it takes for a network print job to be canceled.
Notes:
• 90 seconds is the factory default setting.
• A setting value of 0 disables the timeout.
• If a value of 1–9 is selected, then the setting is saved as 10.
Banner Page
Off
On
Allow the printer to print a banner page.
Note: Off is the factory default setting.
TCP/IP menu
Note: This menu is available only in network models or printers attached to print servers.
To access the menu, navigate to any of the following:
• Network/Ports > Standard Network > Standard Network Setup >TCP/IP
• Network/Ports > Network [x] > Network [x] Setup >TCP/IP
Use To
Activate
On
Off
Activate or deactivate TCP/IP.
Note: On is the factory default setting.
Set Hostname Set the current TCP/IP host name.
Note: This can be changed only from the Embedded Web Server.
IP Address View or change the current TCP/IP address.
Note: Manually setting the IP address sets the Enable DHCP and Enable Auto IP
settings to Off. It also sets Enable BOOTP and Enable RARP to Off on systems that
support BOOTP and RARP.
Netmask View or change the current TCP/IP netmask.
Gateway View or change the current TCP/IP gateway.
Enable DHCP
On
Off
Specify the DHCP address and parameter assignment setting.
Note: On is the factory default setting.
Enable RARP
On
Off
Specify the RARP address assignment setting.
Note: On is the factory default setting.
Enable BOOTP
On
Off
Specify the BOOTP address assignment setting.
Note: On is the factory default setting.
Enable Auto IP
Yes
No
Specify the Zero Configuration Networking setting.
Note: Yes is the factory default setting.
Understanding printer menus 150