Filter
Top Products
Understanding printer messages
Message What this message means What you can do
Programming Error P<x>
An error occurred while the
printer was programming code
into memory.
Correct the problem specified on the
second line of the display:
• P105—A network file was used to
program a non-network printer, or
a non-network file was used to
program a network printer.
• P109—An update file was used to
program the printer, but the
information did not fit within the
space allocated in the Master Boot
Record.
• P112—An upddle.fls file was used
to update the DLE code on a
printer with a firmware card
installed, but the DLE was not
found on the firmware card.
• P200—No firmware card is
installed.
Queuing and Deleting
Jobs
The printer is deleting one or
more held jobs and sending one
or more jobs to print.
Wait for the message to clear.
See also: Printing and deleting
held jobs
Queuing Jobs
The printer is sending one or
more held jobs to print.
Wait for the message to clear.
See also: Using the Print and Hold
function
Ready
The printer is ready to receive
and process print jobs.
Send a job to print.
Ready Hex
The printer is in Hex Trace mode
and is ready to receive and
process print jobs.
• Send a job to print. All data sent to
the printer is printed in
hexadecimal and character
representation. Control strings are
printed, not executed.
• Turn the printer off and then on to
exit Hex Trace mode and return to
Ready status.
Remove Paper <specified
bin>
The specified output bin, or bins,
is full.
Remove the stack of paper from the
specified bin(s) to clear the
message.
Resetting
Maint Cnt Value
The printer is resetting the
counter that tracks wear on the
fuser.
Wait for the message to clear.
Resetting the Printer
The printer is resetting to the
current default settings. Any
active print jobs are canceled.
Wait for the message to clear.
Understanding printer messages
101