Filter
Top Products
Using printer menus
Menu Item Purpose Values
Staple Alarm To specify how the printer
responds when it is out of staples.
Off Load Staples is displayed until
someone loads staples. If an Auto
Continue value is selected from
the Setup Menu, the printer
resumes printing after the
specified timeout value.
Single* Printer stops printing, displays
Load Staples, and sounds three
quick beeps.
Continuous Printer stops printing, displays
Load Staples, and repeats three
beeps every 10 seconds until the
staple cartridge is replaced.
Toner Alarm To specify how the printer
responds when it is low on toner.
Off An error message is displayed until
someone replaces the toner
cartridge. If an Auto Continue
value is selected from the Setup
Menu, the printer resumes printing
after the specified timeout value.
Single* Printer stops printing, displays an
error message, and sounds three
quick beeps.
Continuous Printer stops printing, displays an
error message, and repeats three
beeps every 10 seconds until the
toner cartridge is replaced.
Wait Timeout To specify the amount of time (in
seconds) the printer waits to
receive additional bytes of data
from the computer. When this
timeout expires, the print job is
canceled.
Wait Timeout is only available
when you use PostScript
emulation. This menu item has no
effect on PCL emulation print jobs.
Disabled Disables Wait Timeout.
15...65535
(40*)
Specifies the amount of time the
printer waits for additional data
before it cancels the job.
Start Page The purpose of this page is to
clean oil from the fuser and
improve OHP quality when printed
after a POR. The default for the
setting is Off.
=On
=Off*
Setup Menu
87