Filter
Top Products
67
Appendix B: Advanced troubleshooting
This illustration represents the operator panel
settings in configuration mode when an indicator light
is blinking. The following tables describe the function
of each setting.
If your printer lights look like
this in configuration mode:
Then your printer: Factory
Default
Parallel Mode 1 setting is on, the factory default.
This setting enables or disables the pull up resistors on the
parallel port signals. It is useful for personal computers that
have open collector outputs on the parallel port signals. Set
Parallel Mode 1 On to disable the resistors or Off to enable
the resistors.
• Do a brief button press to scroll through the settings (On,
Off) for this menu item.
• Do a double button press to scroll to the next menu item,
Parallel Mode 2.
• Do a long button press to select and save a setting for
this menu. As the setting is saved, all operator panel
indicator lights remain on for approximately 2 seconds.
Turn off the printer to exit Configuration Mode.
On