Filter
Top Products
1
2
3
4
5
1 Right side 100 mm (3.9 in.)
2 Front 482.6 mm (19.5 in.)
3 Left side 100 mm (3.9 in.)
4 Rear 100 mm (3.9 in.)
5 Top 393.7 mm (15.5 in.)
Printer configurations
CAUTION—TIPPING HAZARD: Floor‑mounted configurations require additional furniture for stability. You must
use either a printer stand or printer base if you are using a high‑capacity input tray, a duplex unit and an input
option, or more than one input option. If you purchased a multifunction printer (MFP) that scans, copies, and
faxes, you may need additional furniture. For more information, see www.lexmark.com/multifunctionprinters.
You can configure your basic printer by adding up to four 550‑sheet optional drawers and a 2000‑sheet high‑capacity
feeder. A caster base and a spacer are supported in any configurations.
Spacers are nonfunctional trays that can be used to add height to a printer stack. Spacers must be:
• Placed directly on a caster base or table top.
• Placed at the bottom of all tray stacks, and cannot be used with an optional 2000‑sheet high‑capacity drawer.
For information on installing the spacers, see the instruction sheet that came with the hardware.
Learning about the printer 11