Lexmark X748DE Printer User Manual


 
Changing port settings after installing a new network Internal Solutions Port
When a new Lexmark Internal Solutions Port (ISP) is installed in the printer, the printer configurations on computers
that access the printer must be updated since the printer will be assigned a new IP address. All computers that access
the printer must be updated with this new IP address.
Notes:
If the printer has a static IP address, then you do not need to make any changes to the computer configurations.
If the computers are configured to use network name that will stay the same, instead of by IP address, then you
do not need to make any changes to your computer configurations.
If you are adding a wireless ISP to a printer previously configured for a wired connection, then make sure the
wired network is disconnected when you configure the printer to operate wirelessly. If the wired connection
remains connected, then the wireless configuration will complete, but the wireless ISP will not be active. In the
event that the printer was configured for a wireless ISP while still attached to a wired connection, disconnect
the wired connection, turn the printer off, and then turn the printer back on again. This will enable the wireless
ISP.
Only one network connection at a time is active. If you want to switch the connection type between wired and
wireless, you must first turn the printer off, connect the cable (to switch to a wired connection) or disconnect
the cable (to switch to a wireless connection), and then turn the printer on.
For Windows users
1
Click , or click Start and then click Run.
2 In the Start Search or Run dialog, type control printers.
3 Press Enter, or click OK.
The printer folder opens.
4 Locate the printer that has changed.
Note: If there is more than one copy of the printer, then update all of them with the new IP address.
5 Rightclick the printer.
6 Click Properties > Ports tab.
7 Select the port from the list, and then click Configure Port.
8 Type the new IP address in the “Printer Name or IP Address” field.
Note: View the printer IP address in the TCP/IP section in the Network/Reports menu. The IP address appears as
four sets of numbers separated by periods, such as 123.123.123.123.
9 Click OK > Close.
For Macintosh users
Add the printer:
For IP printing:
Additional printer setup 55