LG Electronics SV-iC5 Series Power Supply User Manual


 
5. Programming keypad
5-3 SV-iC5
5.3 Moving to other groups
There are 4 different parameter groups in SV-iC5 series as shown below.
Drive group Basic parameters necessary for the inverter to run. Parameters such as Target
frequency, Accel/Decel time are settable.
Function group 1 Basic function parameters to adjust output frequency and voltage.
Function group 2 Advanced function parameters to set parameters for such as PID Operation
and second motor operation.
I/O (Input/Output)
group
Parameters necessary to make up a sequence using Multi-function
input/output terminal.
Moving to other parameter groups
is only available in the first code of each group as
the figure shown below.
Moving to other groups using the Right (X) key Moving to other groups using the Left (W) key
Function
group 1
Function
group 2
I/O group
Drive group
Function
group 1
Function
group 2
I/O group
Drive group
* Target frequency can be set at 0.0 (the 1
st
code of drive group). Even though the preset value is 0.0, it is user-settable.
The changed frequency will be displayed after it is changed.
I/O group
Function
g
roup 1
Drive group
Function
g
roup
2