Filter
Top Products
5. Programming keypad
5-6 SV-iC5
For changing code from any codes other than F 0
When moving from F 1 to F 15 in Function group 1.
1
-. In F 1, continue pressing the Up (S) key until
F15 is displayed.
2 -. Moving to F15 has been complete.
♣ The same rule applies to Function group 2 and I/O group.
♣ Note: Some codes will be skipped in the middle of increment (S)/decrement (T) for code change. That is
because it is programmed that some codes are intentionally left blank for future use or the codes user does not
use are invisible. For example, when F23 [High/low frequency limit select] is set to “O (No) ”, F24 [High frequency
limit] and F23 [Low frequency limit] are not displayed during code change. But When F23 is set to “1(Yes)”, F23
and F24 will appear on the display.