Filter
Top Products
Chapter 4
Advanced Configuration
31
10/100 4-Port VPN Router
Firewall > Access Rules
Access Rules
Except for the default rules, all configured access rules
are listed in the Access Rules table, and you can set the
priority for each custom rule.
If the Access Rules table has multiple pages, select a
different page to view from the Jump to drop-down menu.
If you want more or fewer entries listed per page, select
a different number from the entries per page drop-down
menu.
For each access rule, the Access Rules table lists the
following:
Priority The priority of the access rule is displayed, 1
indicating the highest priority. To change its priority, select
a different priority from the drop-down menu. (When an
access rule is created, the Router automatically assigns a
priority; however, you can change the priority after the
rule is created.) If there is a conflict between two access
rules, then the higher priority rule takes precedence. The
default access rules have the lowest priority.
Policy Name The name of the access rule is displayed.
Enable The status of the access rule is displayed. To
enable or disable a rule, click the Enable check box.
Action The Action, Allow or Deny, is displayed.
Service The Service is displayed.
Source Interface The Source Interface, LAN or WAN1/2,
is displayed.
Source The specific Source is displayed.
Destination The specific Destination is displayed.
Time The time interval to which the access rule applies
is displayed.
Day The days to which the access rule applies is
displayed.
Click Edit to edit an access rule, or click the Trash Can icon
to delete an access rule.
Click Add New Rule to add new access rules, and the Add
a New Access Rule screen appears.
Click the Restore to Default Rules to restore the default
rules and delete the custom access rules.
Add a New Access Rule
Add a New Access Rule
Services
Wizard If you need help to configure the access rules,
click Wizard, and follow the on-screen instructions. For
additional information, refer to the “Wizard” section of this
chapter.
Enter Policy Name Enter a name for the new access
rule.
Action Select Allow or Deny, depending on the purpose
of the access rule.
Service Select the Service you want.
If the Service you need is not listed in the menu, click
Service Management to add the new service. The Service
Management screen appears.