Filter
Top Products
Chapter 4
Advanced Configuration
41
10/100 4-Port VPN Router
VPN > Client to Gateway
NOTE: The 10/100 4-Port VPN Router
supports IPSec VPN client software,
including the Linksys QuickVPN software.
To manage access for Linksys QuickVPN
clients, click the VPN Client Access tab. (For
more information about QuickVPN, refer to
“Appendix B: Linksys QuickVPN for Windows
2000, XP, or Vista”.)
Add a New Tunnel
Tunnel/Group VPN To create a tunnel for a single VPN
client, select Tunnel. To create a tunnel for multiple VPN
clients, select Group VPN. The Group VPN feature facilitates
setup and is not needed to individually configure remote
VPN clients.
Depending on your selection, the Local Group Setup and
Remote Client Setup settings will differ. Proceed to the
appropriate instructions for your selection.
Tunnel
Tunnel No The tunnel number is automatically
generated.
Tunnel Name Enter a name for this VPN tunnel, such as
Los Angeles Office, Chicago Branch, or New York Division.
This allows you to identify multiple tunnels and does not
have to match the name used at the other end of the
tunnel.
Interface Select the appropriate WAN port, WAN1 or
WAN2 (available if the Dual WAN feature is enabled).
Enable Check this box to enable a VPN tunnel.
Local Group Setup
Local Security Gateway Type
Select the type you want to use: IP Only, IP + Domain
Name(FQDN) Authentication, IP + E-mail Addr.(USER
FQDN) Authentication, Dynamic IP + Domain
Name(FQDN) Authentication, or Dynamic IP + E-
mail Addr.(USER FQDN) Authentication. Follow the
instructions for the type you want to use.
NOTE: The Local Security Gateway Type you
select should match the Remote Security
Gateway Type selected on the VPN device at the
other end of the tunnel.
IP Only
The default is IP Only. Only the device with a specific IP
address will be able to access the tunnel.
Local Security Gateway Type > IP Only
IP address The WAN (or Internet) IP address of the Router
automatically appears.
IP + Domain Name(FQDN) Authentication
The IP address and FQDN must match the Remote Security
Gateway of the remote VPN device, and they can only be
used for one tunnel connection.
Local Security Gateway Type > IP + Domain Name(FQDN)
Authentication
Domain Name Enter the Fully Qualified Domain Name
(FQDN), which is the host name and domain name for a
specific computer on the Internet.
IP address The WAN (or Internet) IP address of the Router
automatically appears.