Filter
Top Products
152
Chapter 9:
SFE2000/SFE2000P Gigabit Ethernet Switch Reference Guide
Chapter
9
• Leave Timeout — Indicates the amount of time the host waits, after requesting to leave the
IGMP group and not receiving a Join message from another station, before timing out. If a
Leave Timeout occurs, the switch notifies the Multicast device to stop sending traffic The Leave
Timeout value is either user-defined, or an immediate leave value. The default timeout is 10
seconds.
3. Define the relevant fields.
4. Click Apply. The IGMP Global Parameters are modified, and the device is updated.
Defining Multicast Bridging Groups
The Multicast Group page displays the ports and LAGs attached to the Multicast service group in the
Ports and LAGs tables. The Port and LAG tables also reflect the manner in which the port or LAGs
joined the Multicast group. Ports can be added either to existing groups or to new Multicast service
groups.
The Multicast Group Page permits new Multicast service groups to be created. The Multicast
Group Page also assigns ports to a specific Multicast service address group. To define Multicast groups:
1. Click Bridging > Bridge Multicast> Multicast Groups. The Multicast Group Page opens:
Multicast Group Page
The Multicast Group Page contains the following fields:
• Enable Bridge Multicast Filtering — Indicates if Bridge Multicast Filtering is enabled on the
device. Bridge Multicast Filtering can be enabled only if Bridge Multicast Filtering is enabled. The
possible field values are:
– Checked — Enables IGMP Snooping on the device.