Filter
Top Products
Chapter 6 Cajun Campus CLI – Layer 2
Cajun P332MF User’s Guide 89
Nvram initialize Command
Use the nvram initialize command to reset the Cajun P330 parameters to the
factory defaults. If no options are specified for this command, only the Layer 2
parameters will be reset.
The syntax for this command is:
nvram initialize [switch|all]
Example:
Cajun_P330-N# nvram initialize
This command will force a factory default and switch-over to
the master module and disconnect your telnet session.
Do you want to continue (y/n) [n]? y
Connection closed by foreign host.
host%
Configure Command
The configure command is not used in the Cajun P332MF switch but is used
with the P333R Router (please see the P333R User Guide).
Rmon history Command
Use the
rmon history command to create an RMON history entry.
The syntax for this command is:
rmon history <history index> <interface> interval <interval>
buckets <number of buckets> owner <owner name>
switch Resets all the switching level parameters (Layer 2 only) throughout
the stack
all Resets all parameters including routing parameters of the
Cajun P333R modules present in the stack
history_index This is the history index number of this entry (it is advisable to
use the same interface number as your history index number.)
interface The Interface number is a unique number for each port which
can be calculated as follows:
1024 x Module Number + Port Number
For example: Port 3 in Module 1 has an Inter Number of 1027.