Filter
Top Products
Chapter 6 Cajun Campus CLI – Layer 2
38 Cajun P332MF User’s Guide
Session Command
Use the session command to open a session with a specific entity in a module of
the stack. For example, you can open a session with the Routing entity of a
Cajun P333R module in the stack, or with an the X330 ATM module entity plugged
into a specific module.
The syntax for this command is:
session [<mod_num> [switch|router|atm]]
Note: Layer 2 commands are only available if you open a switch session with the
Master module.
Router commands are described in the Cajun P333R User’s Guide.
Example:
Cajun_P330-N# session 2 router
Note: When you use the session command the security level stays the same.
Terminal Commands
Use the
terminal width and terminal length commands to set the width
and length of the terminal display in characters.
The syntax for this command is:
terminal {width|length} [<characters>]
mod_num (optional) Number of the module.
If you do not specify this parameter, you will get the default
entity of the stack (Layer 2 session to the Master)
switch|router|atm (optional) The entity to which you want to open a session
If you do not specify this parameter, you will get the default
entity of the specific module:
switch - Layer 2 entity of the module (see Note below)
router - Cajun P333R Routing entity
atm - X330 Access module ATM entity