Filter
Top Products
Chapter 6 Cajun Campus CLI – Layer 2
78 Cajun P332MF User’s Guide
Set port channel Command
Use the set port channel command to enable or disable a Link Aggregation
Group (LAG) interface on the module. You can also add or remove a port from an
existing LAG. Ensure that all ports in the LAG are configured with the same ports’
parameters such as port speed, duplex mode, VLAN ID, tagging mode, priority
level. When adding a port to an existing LAG, type the same LAG-name (or no
LAG-name), otherwise you will get an error message. The added port must belong
to the same connector octet - refer to the “LAG” indication on device’s front panel.
The syntax for this command is:
set port channel <mod_num>/<port_list> {on|off} [<LAG-name>]
Example:
Cajun_P330-N# set port channel 1/6,18 on server2
Port 1/6 channel mode set to on
Port 1/18 was added to channel
Set port redundancy on/off Command
Use the set port redundancy command to define/remove redundancy
schemes between a Primary and a Secondary link. The link can be any port that
does not belong to a LAG, or a LAG interface. In either case, there should not be
any redundancy scheme already defined on any of the links.
The syntax for this command is:
set port redundancy <mod_num>/<prim_port_num> <mod_num>/
<second_port_num> {on/off} [<redundancy_name>]
Example:
Cajun_P330-N# set port redundancy 1/7 2/12 on red1
uplink: Port 2/12 is redundant to port 1/7.
Port redundancy is active - entry is effective immediately
port_list A list of ports to be aggregated, separated by commas
LAG-name Optional name for the LAG interface
prim_port_num Primary link of the redundancy scheme
second_port_num Secondary link of the redundancy scheme
redundancy_name Name for the redundancy scheme (optional)