Filter
Top Products
Chapter 6 Cajun Campus CLI – Layer 2
82 Cajun P332MF User’s Guide
Example:
Cajun_P330-N# set auto-negotiation-flowcontrol-advertisement
1/51 asym-tx-only
Cajun_P330-N# Port 1/51 pause capabilities was set
Set trunk Command
Use the set trunk command to configure the tagging mode.
The syntax for this command is:
set trunk <mod_num>/<port_num> {off|dot1q}
Example:
Cajun_P330-N# set trunk 1/19 dot1q
Dot1Q VLAN tagging set on port 1/19.
Cajun_P330-N# set trunk 1/19 off
No VLAN tagging set on port 1/19.
Set spantree Commands
Use the set spantree command to enable/disable the spanning-tree protocol
for the stack.
The syntax for this command is:
set spantree {enable|disable}
Example:
Cajun_P330-N# set spantree enable
bridge spanning tree enabled.
off Forces the port to become a non-tagging port. The port is in the
clear (tagging) mode: it will never send frames as tagged, but it
will correctly interpret received tagged frames.
dot1q Forces the port to become a 802.1Q tagging port. The port is in
the tagging mode: it will send frames as tagged and will
correctly interpret received untagged frames.