Filter
Top Products
Chapter 6 Cajun Campus CLI – Layer 2
Cajun P332MF User’s Guide 39
Clear screen Command
The clear screen command clears the current terminal display.
The syntax for this command is:
clear screen
Ping Command
Use the ping command to send ICMP echo request packets to another node on
the network.
The syntax for this command is:
ping [host[number]]
Note: You can use this command via the Master module only.
Example:
To ping the IP number 149.49.48.1 ten times:
Cajun_P330-N> ping 149.49.48.1 10
ping 149.49.48.1 10: 56 databytes
64 bytes from 149.49.48.1: icmp_seq=0. time=8 ms
Show Commands Summary Table
Following is a table of the show commands:
host Host IP address/Internet address of route destination. If missing then
the last host IP is used.
number Number of packets to send. If missing then the last number is used
• show time Show current time Page 41
• show timezone Show the current timezone offset Page 41
• show ntp Display the current Network Time
Protocol (NTP) status and parameters
Page 41
• show ip route Show IP routing table entries Page 42
• show image
version
Show the image version Page 42
• show snmp Show SNMP community strings Page 43
• show snmp retries Show SNMP retries number Page 43
• show snmp timeout Show SNMP timeout Page 43