Filter
Top Products
Chapter 5 Cajun Campus CLI - Architecture, Access & Conventions
30 Cajun P332MF User’s Guide
Establishing a Serial Connection
Perform the following steps to connect a terminal (physical or emulation) to the
Cajun P330 Master Switch Console port for configuration of Stack or Router
parameters:
1 Use the serial cable supplied to attach the RJ-45 console connector to any
Console port of the Cajun P330 Master Switch. Connect the DB-9 connector to
the serial (COM) port on your PC/terminal.
2 Ensure that the serial port settings on the terminal are 9600 baud, 8 bits, 1 stop
bit and no parity.
3 When you see the “Welcome to Cajun P330” menu and are prompted for a
Login Name, enter the default login. The default login is
root.
4 When you are promoted for a password, enter the password
root.
5 Now you can establish a connection to the Router or the Master switch
(indicated when the SYS front panel LED is ON) using the Session commands
(see Cajun P330 Sessions on Page 31 for details) and begin configuration of
Stack or Router parameters.
Establishing a Telnet Connection
Perform the following steps to establish a Telnet connection to the Cajun P330 for
configuration of Stack or Router parameters. You can Telnet either the Stack
Master IP address or directly to one of the Router IP address:
1 Connect your station to the network.
2 Verify that you can communicate with the Cajun P330 using Ping to the IP of
the Cajun P330. If there is no response using Ping, check the IP address and
default gateway of both the Cajun P330 and the station
Note: The Cajun P330 default IP address is 149.49.32.134 and default subnet mask
is 255.255.255.0.
3 From the Microsoft Windows
®
taskbar of your PC click Start and then Run (or
from the DOS prompt of your PC), then start the Telnet session by typing:
telnet <Cajun_P330_IP_address> For example: telnet
149.49.32.134
4 If the IP Address in Telnet command is the IP address of the stack, then
connection is established with the Switch CLI entity of the Master module.
If you want to connect to the Router CLI entity, use the session command.
If the IP address in the Telnet command is of the router, connection is
established to the Router CLI entity in the router module.When you see the
“Welcome to P330” menu and are prompted for a Login Name, enter the
default name
root
5 When you are prompted for a password, enter the password root in lower